Based Reverse Engineering

12 m Boat – 3D Scan-Based Reverse Engineering & Design Modification

A comprehensive reverse engineering and design modification study was carried out based on the existing mould and geometry of a previously built 12-metre boat.

parasailing_side_view

The project was initiated to accommodate new design and performance requirements while retaining and modifying the existing platform. The original geometry was captured and used as the basis for the development of revised structural, exterior and arrangement solutions.

The scope included the structural redesign and restoration of the aft engine compartment, superstructure and centre console revisions, modification of the bulwark profile, and extensive changes to the aft arrangement.

The toilet compartment and engine room arrangement were revised, the aft section was redesigned, and a dedicated steering compartment was incorporated into the new layout. A parasailing take-off and elevated operating platform was also integrated into the vessel configuration as part of the operational requirements.

parasailing_perspective_image

The reverse engineering process provided an accurate digital basis for coordinating the existing geometry with the new design requirements and for developing the subsequent engineering and production documentation.

parasailing_with_take-off_platform
parasailing_center_console

Scope of Work

  • 3D Scan-Based Reverse Engineering
  • Existing Mould & Geometry Reconstruction
  • Aft Engine Compartment Structural Modification
  • Superstructure & Centre Console Revision
  • Bulwark Profile Modification
  • Engine Room & Toilet Compartment Rearrangement
  • Aft Section / Stern Modification
  • Steering Compartment Integration
  • Parasailing Platform Integration
  • Production-Oriented Design Development